“How to install driver of optical-network-card and setup the ip-config”版本间的差异
来自cslt Wiki
第8行: | 第8行: | ||
# First check the chip-type and adapter-type of the network-card. | # First check the chip-type and adapter-type of the network-card. | ||
# Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers. | # Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers. | ||
− | # Download the source code of driver and then compile it on your target machine according to the README in src | + | # ln /usr/src/kernels/xxx.x86_64 /usr/src/linux |
+ | # Download the source code of driver and then compile it on your target machine according to the README in src. | ||
:# make & make install | :# make & make install | ||
:# modinfo ./ixgbe.ko | :# modinfo ./ixgbe.ko | ||
第17行: | 第18行: | ||
== Ip-config settings == | == Ip-config settings == | ||
# Run "systemctl start NetworkManager" and "nmtui" to grab the name of the new card. | # Run "systemctl start NetworkManager" and "nmtui" to grab the name of the new card. | ||
− | # Copy raw electric-network-card config to the optical one."cp ifcfg-enp0s31f6 ifcfg-enp4s0" | + | # Copy raw electric-network-card config to the optical one."cp ifcfg-enp0s31f6 ifcfg-enp4s0". |
− | # ifdown the electric-network-card && ifup optical-network-card | + | # ifdown the electric-network-card && ifup optical-network-card. |
− | # Restart the network "systemctl restart network" | + | # Restart the network "systemctl restart network". |
2018年12月9日 (日) 11:33的版本
Optical port network card plugging
- First verify the type of your Optical-network, usually PCI-E (x8/x16).
- Scan the mother-board to check if there are any PCI-E(x8/x16) left, then plug the card to the match one.
- Run "lspci |grep net" to see the numbers of network-card.
- Run "ethtool enp4s0" to check the speed property of the network-card. 1000 or 10000bits/s
Driver install(ixgbe)
- First check the chip-type and adapter-type of the network-card.
- Go to https://www.intel.com/content/www/us/en/support/products/36773/network-and-i-o/ethernet-products.html to find the corresponding drivers.
- ln /usr/src/kernels/xxx.x86_64 /usr/src/linux
- Download the source code of driver and then compile it on your target machine according to the README in src.
- make & make install
- modinfo ./ixgbe.ko
- remove ixgbe
- insmod ixgbe
- modprobe ixgbe
Ip-config settings
- Run "systemctl start NetworkManager" and "nmtui" to grab the name of the new card.
- Copy raw electric-network-card config to the optical one."cp ifcfg-enp0s31f6 ifcfg-enp4s0".
- ifdown the electric-network-card && ifup optical-network-card.
- Restart the network "systemctl restart network".